TRACK HEAD INSTALLATION
1. PULL SLEEVE ON TRACK. ADAPTOR DOWNWARD BEFORE PLACING TRACK HEAD IN DESIRED POSITION. MAKE SURE THE TWO CONTACT FINGERS. ON ADAPTOR ARE ON THE SAME SIDE AS COPPER SLOTS ON INSIDE OF TRACK.
2. ROTATE ADAPTOR 90°UNTIL TRACK HEAD LOCKS INTO PLACE ON TRACK（SEE ILLUSTRATION 4）
IMPORTANT: IF ADAPTOR DOES NOT TURN FREELY. DO NOT FORCE ! INSTEAD, TURN IN THE OPPOSITE DIRECTION.
3. TO RE-POSITION OR REMOVE TRACK HEAD, PULL DOWN THE SLEEVE DUTSIDE THE ADAPTOR AND ROTATE 90°
CAUTION:
REFER TO THE LABEL LOCATED INSIDE THE LAMP HEAD FOR RECOMMENDED MAXIMUM BULB WATTAGE, DO NOT EXCEED RECOMMENDED MAXIMUM WATTAGE.
INSTALLATION INSTRUCTIONS
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE TRACK LIGHTING SYSTEM.
NOTICE: REFER TO THE " IMPORTANT SAFETY INSTRUCTIONS " SUPPCIED WITH YOUR LOCAL TRACK LIGHTING.
1. PULL SLEEVE ON TRACK ADAPTOR DOWNWARD BEFORE PLACING TRACK HEAD IN DESIRED POSITION. MAKE SURE THE TWO CONTACT PINS ON ADAPTOR TURN TOWARD THE SIDE OF THE TRACK THAT HAS TWO COPPER BUS BARS.
2.ROTATE ADAPTOR 90 DEGREE UNTIL TRACK HEAD LOCKS INTO PLACE ON
TRACK.
3.TO REMOVE OR REPOSITION TRACK HEAD, PULL DOWN THE SLEEVE OF THE
ADAPTOR AND TURN 90 DEGREE.